Mechanical Engineering Questions And Answers :: Refrigeration And Air Condition: part3



Mechanical Engineering : Refrigeration And Air Condition QUESTIONS AND ANSWERS :: part3 : 6 to 10

Following Mechanical Engineering Multiple choice objective type questions and answers will help you in BSNL JTO, GATE 2024 and IES 2024 examinations :

6.One ton of the refrigeration is

the standard unit used in refrigeration problems
the cooling effect produced by melting 1 ton of ice
the refrigeration effect to freeze 1 ton of water at 0�C into ice at 0�C in 24 hours
the refrigeration effect to produce 1 ton of ice at NTP conditions
the refrigeration effect to produce 1 ton of ice in 1 hour time.

7.For proper refrigeration in a cabinet, if the temperature and vapour pressure difference between cabinet and atmosphere is high, then

bigger cabinet should be used
smaller cabinet should be used
perfectly tight vapour seal should be used
refrigerant with lower evaporation temperature should be used
refrigerant with high boiling point must be used.

8.In vapour compression refrigeration system, refrigerant occurs as liquid between

condenser and expansion valve
compressor and evaporator
expansion valve and evaporator
compressor and condenser
none of the above.

9.If the evaporator temperature of a plant is lowered, keeping the condenser temperature constant, the h.p. of compressor required will be

same
more
less
more/less depending on rating
unpredictable.

10.The lower horizontal line of the refrigeration cycle plotted on pressure-enthalpy-diagram represents

condensation of the refrigerant vapour
evaporation of the refrigerant liquid
compression of the refrigerant vapour
metering of the refrigerant liquid
none of the above.

More Refrigeration And Air Condition QUESTIONS AND ANSWERS available in next pages

    Health is the greatest gift, contentment is the greatest wealth -Buddha
Failure defeats losers, failure inspires winners.-Robert T. Kiyosaki