Electrical Engineering Questions And Answers :: Measurement And Instrumentation: part2



Electrical Engineering : Measurement And Instrumentation QUESTIONS AND ANSWERS :: part2 : 6 to 10

Following Electrical Engineering Multiple choice objective type questions and answers will help you in BSNL JTO, GATE 2024 and IES 2024 examinations :

6.In a low power factor wattmeter the pressure coil is connected

to the supply side of the current coil
to the load side of the current coil
in any of the two meters at connection
none of the above

7.Murray loop test can be used for location of

ground fault on a cable
short circuit fault on a cable
both the ground fault and the short-circuit fault
none of the above

8.An induction wattmeter can be used for

both D.C. and A.C.
D.C. only
A.C. only
any of the above

9.It is required to measure the true open circuit e.m.f. of a battery. The best device is

D.C. voltmeter
Ammeter and a known resistance
D.C. potentiometer
None of the above

10.The operating voltage of a meggar is about

6 V
12 V
40 V
100 V

More Measurement And Instrumentation QUESTIONS AND ANSWERS available in next pages

    Health is the greatest gift, contentment is the greatest wealth -Buddha
The only place where success comes before work is in the dictionary.- Vidal Sassoon