Civil Engineering Questions And Answers :: Applied Mechanics And Graphic Statics: part1

Exam2win > Engineering > Civil Engineering > Applied Mechanics And Graphic Statics > part1



Civil Engineering : Applied Mechanics And Graphic Statics QUESTIONS AND ANSWERS :: part1 : 16 to 20

Following Civil Engineering Multiple choice objective type questions and answers will help you in BSNL JTO, GATE 2024 and IES 2024 examinations :

16.The torque produced by a force depends on i) the magnitude of the force ii) the direction of the force iii) the'point of application of the force relative to origin The correct answer is

only (i)
both (i) and (ii)
both (i) and (iii)
all (i), (ii) and (iii)

17.A rod AB carries three loads of 30 N, 70 N and 100 N at distances of 20 mm, 90 mm and 150 mm respectively from A. Neglecting the weight of the rod, the point at which the rod will balance is

109.5 mm from A
119.5 mm from A
125.5 mm from A
132.5 mm from A

18.If the resultant of two forces has the same magnitude as either of the force, then the angle between the two forces is

30�
45�
60�
120�

19.The angular speed of a car while taking a circular turn of radius 100m at 36 km/hour, is

0.1 radian/sec
1 radian/sec
100 radian/sec
1000 radian/sec

20.A hoop of radius 3 m weighs 100 kg. It rolls along a horizontal floor so that at its centre of mass has a speed of 200 mm/sec, . The work required to stop the hoop is

2 J
4 J
6 J
8 J

More Applied Mechanics And Graphic Statics QUESTIONS AND ANSWERS available in next pages

    Health is the greatest gift, contentment is the greatest wealth -Buddha
The only place where success comes before work is in the dictionary.- Vidal Sassoon